V-9T
價格
描述
The V-9T is revolutionary Triple power amplifier, designed for permanently installed sound systems where rackspace is at a premium, high performance Class AB complementary bipolar output circuitry. That 3 CH independent outputs requested most by contractors and installers. Also CH1&2 is can bridge mode for your high power speaker systems. Using the V-9T for L & R Main and 1 Monitor CH or zoned speaker applications.
- 300W + 300W + 300W at 4 ohms.
- Or 300W at 4 ohm + 600W at 8 ohm.
- Individual logical LED meters are present for power in/output level.
- Ultra low noise.
- FET control quiet power on/off muting circuit.
- Individual full protection circuit.
- Lowest in-rush Trodial Transformers.
- 2U space rack mountable.
| Model | V-9T | |||
| Tri Mode (both channel driven) | Continuous Average Output Per Channel | |||
| FTC @ THD+N=0.1%, f=20Hz~20kHz | CH1 | Mono(CH1+CH2) | CH2 | CH3/monitor |
| 8 ohm/Stereo | 210W | 580W | 210W | 210W |
| 4 ohm/Stereo | 300W | N/A | 300W | 300W |
| EIA @ THD+1=1%, f=1kHz | ||||
| 8 ohm/Stereo | 220W | 600W | 220W | 220W |
| 4 ohm/Stereo | 310W | N/A | 310W | 310W |
| Power Bandwidth (Ref. 1kHz, THD+N=0.1%,+0/-1dB) |
20Hz~25kHz | |||
| THD+N (Ref. 1kHz,f=20Hz~20kHz) |
≤0.05% | |||
| Frequency Response (Ref. 1kHz, 1watt output, +0/-1.5dB) |
20Hz~35kHz | |||
| IMD(SMPTE4:1) (60Hz:7kHz, 4:1 Half power) |
||||
| 4-8 ohm/Stereo | ≤0.1% | |||
| Crosstalk (RL=8Ω, Half power, Att.Max 600Ω shunt) |
≥90dB, 1 kHz | |||
| Residual Noise (20Hz~22kHz LPF,Att.min) |
≥76dB | |||
| S/N Ratio (Filter:A-Weighting, RMS) |
≥105dB | |||
| Damping Factor (RL=8Ω, f=1kHz) |
≥350 | |||
| Input Sensitivity (Att. max) | ||||
| 4 ohm/Stereo | +4.0 dBu | |||
| 8 ohm/Bridge | +5.1 dBu | |||
| Voltage Gain(Att. max) | 30.5dB | |||
| Output Circuitry | AB | |||
| Input Impedance | 10kΩ(Unbalance), 20kΩ(Balance) | |||
| Controls | AC Switch,Ch1 and Ch2 gain Control knobs Stereo/Mono Bridge Switch(CH 1&2) |
|||
| Connectors | XLR jack, 1/4" TRS jack Touch-Proof binding posts |
|||
| Indicators | Power(Green),Protect(Red),Clip(Red), Signal level,Bridge(AMB) |
|||
| Protection Circuits | 1)Short Circuits 2)Current Limit 3)DC detection 4)Thermal 5)Turn On/Off muting 6)AC Line fuse |
|||
| Fan Circuit | Single Fans Variable low Speed(50℃), High speed(55℃) |
|||
| Power Consumption | 1350 Watts | |||
| DIMENSION | 482mm X 88mm X 410mm | |||
| Weight | 16.22kg | |||
